CNC Operator in Artesia, CA at Carlisle Interconnect Technologies

Date Posted: 10/15/2019

Job Snapshot

  • Employee Type:
    Part-Time
  • Location:
    Artesia, CA
  • Job Type:
  • Experience:
    Not Specified
  • Date Posted:
    10/15/2019

Job Description



Receives direction from the Machine Shop Supervisor or Area Lead; his/her primary responsibilities are to set up and run Machines; completing all task assigned according to the Router and Blue Print. Comply with all Machine Shop Processes; including but not limited to all WI, (Work Instruction) MI, (Manufacturing Instruction) and OP, (Operating Procedures). All tasks should be performed accurately, timely and without instruction.

ESSENTIAL JOB FUNCTIONS

• Accept responsibility for decisions, actions and mistakes.
• Receive Machine Shop Paper, (MSP), and take responsibility of running machines.
• Change machine tools as needed with little assistance. Adjust offsets to achieve maximum machine performance.
• Understand Blue Prints and interpret geometrical tolerances.
• Complete all coordinating documents, First Article Sheet, MSP, Overall Equipment Effectiveness, (OEE) and 5s.
• Provide First Article Inspection, (FAI).
• Troubleshoot and evaluate machining problems and communicate clearly and effectively the discrepancies.
• Able to use all inspection equipment essential to the task.
• Support the Quality System by promoting compliance to the company's Quality Manual, procedures and policies.
• Performs additional duties within the Machine Shop department as assigned.
*Other duties may be assigned*
Physical Demands:

• Combined sitting, standing, and walking throughout the day to accomplish tasks.
• Ability to sit or stand for long periods when performing and reporting on tasks
• Occasional lifting up to 25 pounds.
• Reaching, stretching, pushing, pulling, climbing, crouching or stooping on a daily basis.
• Specific vision abilities include close vision and the ability to adjust focus.


To perform this job successfully, an individual must be able to perform each essential job function satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

• Three or more years as a machinist using conventional equipment.
• High School diploma or equivalent.
• Good understanding of shop math, geometry, trigonometry, and blueprint reading.
• Good oral and written communication skills.
• Hand dexterity, coordination, and accuracy.
• Ability to communicate and interface well with a wide range of people.
• Attentive to detail.
LANGUAGE SKILLS
Ability to read, write, speak, and understand English.
Equal Opportunity Employer Minorities/Women/Protected Veterans/Disabled